Hator HTA-845 Hyperpunk 2 Headphones with microphone 7.1

Full functionality and ultra-lightweight design.

Built to meet any customization needs and accompany you during long battles.

High volume and detail are guaranteed.

50 mm speakers with a resistance of 64 Ohms, equipped with a composite membrane and a neodymium magnet, are responsible for high-quality sound

The ultra-light design allows you to use the headset for a long time without any discomfort. The weight is only 180g!

Ergonomic fabric ear cushions provide improved air circulation, which prevents ear heating and discomfort during prolonged use. Memory foam is used as a filler for the ear cushions, which allows for even distribution of pressure and prevents fatigue.

An excellent microphone will ensure high-quality recording during a game or work video conference. If necessary, the microphone is easily disconnected, and the connector hole can be hidden under the included plug.

The included sound card supports proprietary software, and will open a large list of additional settings for both the reproduced sound and recording from the microphone. Activate multi-channel 7.1 surround sound, adjust the equalizer and much more!

Specifications

Headphone

Speakers: 50mm with neodymium magnet

Frequency range: 10Hz – 22kHz

Impedance: 64Ω ± 15%

Sensitivity: 114dB ± 3dB

Maximum power output: 20mW

Cable length: 1m + 1.5m USB

Connection jack: 3.5 mm combined (headphones and microphone), USB

Approximate weight: 180 ± 5g

Microphone

Microphone: 6mm*2.7mm omnidirectional

Frequency range: 100Hz – 10kHz

Signal-to-noise ratio: ›64dB

Sensitivity: -42 ± 3dB

Sound card

Connection: USB Type-A

Input connector: 3.5mm for 4-pin jack

Bit rate: 16 bit

Operating voltage: 4V

Maximum sampling rate: 48kHz

Signal-to-Noise ratio: 93.6dB

Cable length: 1.5m

Controls: Volume up/down,

microphone mute,

speaker mute.

Package of contents:

HATOR Hyperpunk 2 USB 7.1 headset

1m detachable audio cable

1.5m USB cable with sound card with a 3.5 mm input

Two rubber plugs for the microphone socket